Machines · The Flip

Problem: Pop bumper light is out

Problem: Level machine

Fireball (Home Edition)

Problem: Pop bumpers could be adjusted to be a little more sensitive. Double bonus switch could be adjusted to be a little more sensitive. Game plays perfectly fine, even without these adjustments.

Dr. Dude and His Excellent Ray

Problem: Some GI lights are out. Replaced bulbs and that didn’t fix the issue. Checked for continuity on fuses and they were all fine. Inspected the backbox and found a scorched wire.

Revenge From Mars

Problem: Replace over-bright bulb (LED?) in back of playfield

The Getaway: High Speed II

Problem: The "2x" light, Green Light, and two of the lights on the pop bumpers are not working--bulbs are fine, we suspect an issue with the connection.

Problem: 1. Disconnected solder on the "Selection 1 arrow" light (photos marked in green) 2. Also appears none of the "Selection" lights are working. Bulbs are in find shape so likely a connection (photo marked in blue)

Problem: A few light sockets and/or related wiring is causing some bulbs to be dimly light or flashing, those are as follows: - Rollover 10 - Clock 3, 6, and 7 The clock light 5, I was unable to place a new bulb within. This will need to be looked at as there is something in the socket that is preventing it from allowing a bulb to sit all the way in. Noting that the old bulb did look corroded and was difficult to remove.

Problem: GI lighting is “blacked out” again

Indiana Jones: The Pinball Adventure

Problem: Volume just randomly spikes in the middle of play, and then readjusted. There seems to be nothing in particular that caused it, just started the game and the volume spiked. Tested it and it hasn’t happened again.

Problem: Figure out a safe way to have the Special hole sensor and rod work again

Medieval Madness

Problem: Ball can get stuck on this switch if it enters the left inlane slowly (which usually doesn’t happen) but should be addressed

Problem: When the Mystery Wheel stops spinning the game awards something different than what the clown is pointing to.

Problem: Machine is down to 7 of 10 pinballs, size 5/8"

Sankyo Type II Pachinko

Problem: This thing gets jammed up all the time. Someone needs to spend time running a lot of balls through it and seeing what isn't reliable. Ask William to show you what the deal is

Problem: Tiny tilt display ball has gone missing

Problem: While no game is being played, periodically seems to be cycling through some components getting triggered, as if a ball is trying to launch. It appears that the plunger is automatically going off. It’s hard to tell if any other component is getting triggered as I haven’t been able to time it to watch for it to happen.

Problem: Some lamps do not work after being replaced with new 555 bulbs (multiball arrow, 5 million targets)

Problem: Replace wire nuts on coin door with better connectors

Classic Pin Bagatelle

Eight Ball Deluxe Limited Edition

Godzilla (Premium)

Ms. Pac-Man (Arcade Game)

Push-On: The Prophets of the Extra-Life